8S Handlebars


1. Straighten out the bike for assembly

Loosen top bolt.

Twist the handlebar stem so that it faces forward.

Straighten fork so that the disc brake caliper will be on the rider's left of the bike.

Tighten top bolt.

2. Remove the faceplate

Find the four bolts at the end of the handlebar stem.

Use the Fortified Security Key to unscrew the bolts.

Set bolts and washers in the bowl for safe keeping after you remove them.

3. Check cabling

Pull your handlebars out from the bike.

Refer to the still image on the left with cables and levers to ensure accurate routing of rear brake and shifter cables. 

The front and rear break cables will both be attached to the brake calipers. 

4. Route rear brake cable under cable guide

Remove cable guide using a flathead screwdriver.

Place rear brake cable under mount.

Reattach cable guide over cable.

5. Attach the faceplate and handlebars

Pull the handlebars up and onto the stem.

The shifter will be on the rider's right. Ensure brake levers are facing forward. Ensure the ridged area of the handlebars is centered under the faceplate.

Place the faceplate over the handlebars and line up the thread holes of the faceplate over corresponding holes on the stem body.

NOTE: We encourage you to hand tighten the bolts until the threads catch to avoid cross-threading, which will damage your product.

Use your fingers to insert and hand tighten the four bolts in a cross pattern.

6. Check Handlebar Alignment

Align the handlebars side to side so the ridged area is centered under the opening of the faceplate and the brake levers are at approximately a 45º angle (+/- 10º) facing downwards. 

7. Secure the Handlebars

Slowly tighten the bolts using the Fortified Security Key.

Screw in each bolt a turn at a time in a cross pattern so that they tighten evenly.

Stop when you can no longer turn the bolts with the key.

NOTE: If the spacing between the stem body and faceplate is uneven from bolt to bolt, you will need to re-center your handlebars under the faceplate. Loosen the bolts and try again until spacing appears even when fully tightened.

8. Tighten the Stem Bolts

     BACK: PEDALS                                                                        NEXT: RIM TAPE